CWP - Cooper-Weymouth, Peterson *
Equipment & Systems
News
About Us
Contact Us
Formtek
CWP Inventory
CWP Knowledgebase / Tips
FORMTEK
   

KB90: Minimum pressure

Category: Miscellaneous Tips | Updated: 6/12/2007 8:26:31 AM | Owner: The Professor | Read: 5185 (Last: 7/22/2019 1:57:09 PM)

Resolution

Nearly all adjustments on coil handling equipment can be thought of as pressure adjustments. Stress that the minimum pressure to do a job is the correct setting for that job. Adjust pressure up gradually until the right results are achieved. Do not fall into the common trap of over-adjusting practically everything which only shortens equipment life.

Related articles
KB89  Proper set-up
KB91  Audio-visual inspection
KB92  Edge guiding
KB93  Feeding inclined presses
KB94  Using prime material
KB95  Stagger blanking
KB96  Coil-equipped dies
KB97  Control stations
KB98  Continuous running
KB99  Channel iron protectors
KB100  Guarding at installation
KB101  Operator instructions

Was this article helpful?
Votes so far: 51% in 3156
Yes | No

                

Hinckley Road, Clinton ME 04927, (207) 426-2351 FAX: (207) 426-8868
Formtek Logo
*
* EQUIPMENT & SYSTEMS | ABOUT US | CONTACT US | FORMTEK | HOME | SITE MAP    
© Copyright 1998-2007 Formtek-ME. All Rights Reserved.  
Yoder Mfg. Dahlstrom Iowa Precision Hill Engineering Lockformer FMI Dahlstrom Formtek Group Winpro Rowe Machinery B&K Levelers Tishken